First thing I would do is unplug everything from the radio except antenna
and power. Then check if it still behaves like that.
73, Barry N1EU
On Wed, Mar 25, 2015 at 3:00 AM, Dick Coates <dick@mbtsa.co.za> wrote:
> I have an Orion 565 with firmware 3.032x5. When I select mode UCW or LCW
> the txcvr immediately goes into tx and transmits a continuous carrier and
> locks in this mode until I change back to USB or LSB.
>
> If the rig in in USB or LSB as soon as I use the tuner the rig locks
> again.
>
>
>
> I seem to recall this started after I inadvertently pressed User1 or User2
> when keying in UCW (but I’m not 100% sure) I have tried a Master Reset
> and also reloading the firmware buit this doesn’t fix the problem. Any
> bright ideas out there please?
>
>
>
> 73 Dick ZS6BUN
>
>
>
> Dick Coates
>
> *MBT South Africa*
>
> *Distributors of Plastics Raw Materials*
>
> Office: +27 11 4552889
>
> Fax: +27 11 4552937
>
> Cell: +27 82 6007398
>
> www.mbtsa.co.za
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|