TenTec
[Top] [All Lists]

Re: [TenTec] NO XMIT WITH PTT

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] NO XMIT WITH PTT
From: Ron <k8fg@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 20 Mar 2005 16:57:29 -0500
List-post: <mailto:tentec@contesting.com>
Steve N4LQ wrote:

>Ron
>Tx Loop button? What's that? In the "Transmitter" menu, I have a "Enable 
>keying loop" button. Is that what you meant? I have mine disabled since I 
>don't use a TT amp with the Peg. On your N4PY front panel, do you have the 
>"Xmit Disable" activated? If so, disable it. Also check the "ACCInp" button. 
>For microphone input it should be disabled.
>If all this doesnt work, try the basic TenTec software and start all over.
>Out of ideas. 73
>Steve Ellington
>N4LQ@iglou.com
>----- Original Message ----- 
>From: "Ron" <k8fg@sbcglobal.net>
>To: <tentec@contesting.com>
>Sent: Saturday, March 19, 2005 2:16 PM
>Subject: [TenTec] NO XMIT WITH PTT
>
>
>  
>
>>Hello to the Group,
>>I have a couple of questions .
>>I have a Pegasus that will not Xmit via the Mic or Acc jacks
>>but will key via the N4PY software with a mouse click on the
>>TX Loop button.. Any ideas ?
>>
>>Also is there ant service info available ?
>>Thanks, Ron/K8FG...
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>    
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>
Hi Steve and Carl,
I have the latest ver of software and in the top row of buttons there is 
a Tx Loop button after the Calibrate.
When I left click on this button it will go into xmit. If I go into the 
settings/transmitter menu and
uncheck Keying Loop the rig goes into xmit. ACCInp is disabled.
I am starting to believe I have a rig problem, if I short the Ptt pin in 
the mic connector to ground
there is no xmit also did the same test with the Acc connector with the 
same results.
Ron/K8FG...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>