John:
Some rigs have to lower their output power if they are going to operate single
or double sideband with carrier. This is so not to exceed the output power
rating of the final device/s upon 100% modulation. Ten-Tec's 100 watt output
is not reduced because they do not operate ssb or dsb w/carrier, except for the
Orion model. Not sure about the new Omni VII.
Regards
Bill Harris w7kxb
----- Original Message -----
From: john ferro<mailto:foxbat426@hotmail.com>
To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.com>
Sent: Sunday, September 30, 2007 1:59 PM
Subject: Re: [TenTec] ten tecs have 100 watts out on carrier??
actually you have not helped me out - you still have not answered the
question - whats the difference between an am carrier and cw carrier? if it's
the same as some people say why on a japanese radio the am carrier is only 25
to 50 watts (depending on the radio) when the mic is keyed vs. 100 watts on the
same jap radio cw mode keyed down - all assuming swr is 1? i understand the swr
fold back issue.> From: OTAKEBI@aol.com<mailto:OTAKEBI@aol.com>> Date: Sun, 30
Sep 2007 16:39:52 -0400> To:
tentec@contesting.com<mailto:tentec@contesting.com>> Subject: Re: [TenTec] ten
tecs have 100 watts out on carrier??> > Yes, Mike.> Now we know what was going
on once he explained it a little better.> I had a TS 180s that at had to see a
perfect, flat, SWR to put out full > output.> Like Ten Tecs better.> Glad we
were able to help him.> Dan/N4VET> > > >
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|