Mike:
I do believe that from the original Paragon and newer models such as the
Omni V, Paragon II, Omni 6 the use of the Airpax breaker is no longer
needed.
Donnie / WA9TGT
On Sep 4, 2012 4:04 PM, "Mike Bryce" <prosolar@sssnet.com> wrote:
> Of course, when running ten tec transceivers, the use of a non factory
> supply increases the need for an air pax fast acting circuit breaker to
> protect the rig's final transistors.
>
> Mike wb8vge
>
> Sent from my iPhone
>
> On Sep 4, 2012, at 2:36 PM, Kimberly Elmore <cw_de_n5op@sbcglobal.net>
> wrote:
>
> > FAR Circuits still offers their "RF Proof 30 A Power Supply" regulator
> board.
> > It's only the PCB -- you need to find the parts and stuff the board.
> It's based
> > on an article in the 1988 ARRL Handbook. I built one for my 30 A Astron
> PS when
> > I learned that it was extremely susceptible to RFI. I could never get
> this
> > regulator to act up. I made mine over 20 y ago and it still works just
> fine.
> > However, it (obviously) applies only to linear supplies.
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|