Carl,
I had read that in archives, but I have not found any original
documentation. The connectors are wired differently - my first fail point
was not having 5 VDC on the encoder. My assumption is that the Paragon II
will need lines added to support the 301. Searching for additional
information now.....
Steve, N0CZV
Attica, Ohio
n0czv@frontier.com
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Carl
Moreschi
Sent: Friday, November 08, 2013 7:41 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Paragon II and 301 Remote
Yes the 301 knob will work with the Paragon II.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|