I'm late chiming in. My problem with the fuses has always been a shorted
tube. You are on the right track. Test one fuse at a time, or start with
one, add another, then the third. BTW a matched set is better than an
unmatched set HOWEVER, I had three misc tubes gathered over the years and put
them in and do pretty well with them. I did that while waiting for a new
matched set. Now the matched set is on the shelf waiting their turn!!!
The guy at the local electronics store said to me one day when I bought a dozen
fuses, "You do know that if you don't fix it then it will still blow fuses!"
good luck,
Kris
Kris KM2KM
MERSCHROD
123 Warren Road
Ithaca, NY 14850
---- Joe Papworth via TenTec <tentec@contesting.com> wrote:
=============
It has stayed on with the tubes removed for a while.?
I'm examining/ohming the tubes now.
-----Original Message-----
From: Carl Moreschi <n4py3@earthlink.net>
To: wb5jnc <wb5jnc@centurytel.net>; Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Sent: Tue, Jan 26, 2016 3:03 pm
Subject: Re: [TenTec] Model 411 amp (aka Centaur)
Don't overlook the possibility on an intermittent short in one of the 811's.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 1/26/2016 2:54 PM, Al Gulseth wrote:
> Joe,
>
> Just an ohms check may not be enough. You may be dealing with an intermittent
> breakdown under high voltage. A "hi-pot" (high potential) test with an
> insulation tester etc. would be the only way to know for sure. A winding
> layer to adjacent layer partial short in the HV side could also account for
> your symptoms, and might not be obvious because the winding resistance could
> show right at the low edge of the manufacturer's spec. (I went through that
> scenario years ago with a HV filter choke in a small AM BC transmitter.)
>
> 73 es GL, Al
>
> On Tue January 26 2016 11:28:03 am Joe Papworth via TenTec wrote:
>> Thanks Andy. Was it the HV secondary that shorted?
>>
>>
>> I isolated the HV secondary from the HV board and it reads open to the
>> frame and chassis. (Reads about 45 ohms when connected to the board)
>>
>>
>> Thanks, Joe, K8MP
>>
>>
>> -----Original Message-----
>> From: P C Andy Anderson<xtraham58@hotmail.com>
>> To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
>> Sent: Tue, Jan 26, 2016 11:52 am
>> Subject: Re: [TenTec] Model 411 amp (aka Centaur)
>>
>>
>>
>>
>> Joe, I had a similar problem with my Centurion AMP. It eventually failed
>> completely. The secondary of the power transformer shorted to the frame. I
>> had the Xformer rewound at TRS. BTW this transformer problem is a known.
>>
>> 73' Andy, W3LI
>>
>> ________________________________________
>>
>>
>> Tuesday noontime, Joe:
>>
>> I have a Centaur..............keep it covered when not in use.
>>
>> My Elmer told me to always keep it covered..................dust is the
>> problem.
>>
>> Even when covered, open it up every two-three years and do a internal
>> cleaning.
>>
>> N1MHC/alsirois
>> =============
>>
>>
>>
>> Gents,
>>
>>
>> Have any of you gone a few rounds with a Centaur amp?
>> I have a one that blows fuses very intermittently. It vaporizes them both,
>> simultaneously, so it's apparently a dead-short somewhere. This happens
>> even in stand-by. (i.e. No key-down)
>>
>>
>> Before I tear into it, anyone have any ideas of common failures in these
>> amps?
>>
>>
>> Later, Joe, K8MP
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|