Jim,
I disagree. Since it is a category I find that some operators appreciate the
information. It sometimes leads to a discussion about our setups.
With regards to miscopying someone. If you cannot intrepret the information
sent because of a weak signal QRM or QRN you have not made a valid contact.
Mike N2MS
----- Original Message -----
From: Jim Brown <jim@audiosystemsgroup.com>
To: topband@contesting.com
Sent: Fri, 25 Dec 2015 20:50:44 -0000 (UTC)
Subject: Re: Topband: re topband QRP
On Fri,12/25/2015 12:24 PM, mstangelo@comcast.net wrote:
> I operate QRP and normally give out that information as well as my power
> levels after the signal report.
As a QRP op myself, I urge you to NOT do that. If I had worked to dig a
weak signal out of the noise, I would interpret ANYTHING after R or TU
as telling me I had miscopied something, and you are repeating
73, Jim K9YC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|