Towertalk
[Top] [All Lists]

Re: [TowerTalk] aircraft bearing

To: towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] aircraft bearing
From: "Alan NV8A (ex. AB2OS)" <nv8a@att.net>
Date: Sun, 31 Jul 2005 14:42:43 -0400
List-post: <mailto:towertalk@contesting.com>
So what would you call a *taper* roller bearing? -- it supports loads in 
two planes.

73

Alan NV8A



On 07/31/05 02:33 pm Dino Darling tossed the following ingredients into 
the ever-growing pot of cybersoup:

> I've been reading this thread with great interest.  I wasn't getting it at 
> first.  Sometimes the term, "thrust bearing" gets confused in the tower 
> arena.  "Thrust Bearing", in my vocabulary, means taking on SIDE loads in one 
> dimension, like a thrust bearing in an engine that prevents the crankshaft 
> from moving fore and aft, but not responsible for supporting that crankshaft. 
>  When we speak of tower masts, we take on loads in two dimensions; vertical 
> and side.
> 
> So this is how I try to separate the two (your mileage may vary).
> 
>   The "bearing" used to take the side loads, I call, a "BUSHING".  I believe 
> the majority of this thread was dealing with this type of bearing.  Simply, 
> it's a 1" thick triangle plate, the size of, and bolted to, the top/rotor 
> plate.  The center of this plate is drilled to accept the 2" mast and prevent 
> it from touching the tower's metal parts.  We rub the bearing rather than the 
> metal tower parts.  On the top of a "pointy" Rohn section, I've used a piece 
> of PVC pipe, the length of the tower tube, as a bushing.  In both examples, 
> they only provide support in one (side) dimension.
> 
>   The "bearing" used to take the vertical loads, I call the THRUST bearing.  
> It's just like the crankshaft, only flipped up vertical.  
> 
> (As a side note, it's my feeling that the majority of the bearings (fanfir) 
> used to support the vertical load of the mast and antennas is used 
> incorrectly.  They were designed to support horizontal shafts parallel (load) 
> to the flange, not how we use them.  But, they seem to work OK.  A taper 
> bearing would be a better option.  IMHO)
> 
> What I don't fully understand at this point, is how the UHMW (plastic) sheet 
> is used to support the vertical load.  I'm assuming you are using 2 sheets.  
> How is the second sheet secured to the mast?  If possible, a picture is worth 
> a thousand words!  :-)
_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>