1.875 in (1 7/8") is 47.625 mm.
Al
AB2ZY
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of CEPitts
Sent: Wednesday, May 26, 2021 10:09 AM
To: towertalk@contesting.com; mpridesti@yahoo.com
Subject: Re: [TowerTalk] Rohn TB-3 thrust bearing
Ugh! Correction, reading the mm wrong, it looks like it should be 59mm!
sorry about that! Charles "Ed' K5OF
On 5/26/2021 9:58 AM, CEPitts wrote:
> Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it
> is off it only by 1mm according to my handy little caliper. If others
> respond hopefully they confirm what I have provided. Charle4s "Ed"
> K5OF in NC
>
> Hello group!
>
> Could someone here give me the precise inside diameter of this
> bearing? Quick checks in the Rohn catalog (over 230 pages) I was
> unable to find it.
>
> Thanks!
>
> Regards,
>
> Mark, K1RX
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|