>
>Anyone with comments on the above mentioned inductor? How would this
>thing work in a
>
>a. 3CX1500A7 amp
>b. 3CX3000A7 amp
>
>covering 160-10m ? Or should I wound again my own coil?
>
For a 3CX3000A7, the approx. tank circulating current with a Q of 12.5 is
2.5A x 12.5 = 31A-rms. Since contact dissipation is: P=I^2 x R, might
not 31A be a bit much to expect from 10A-rated contacts?.
- later, Carsten
> 2-10 kw Power Handling
> Taper Wound Front End
> Edge Wound Coil All Silver Plated
>
>(IRV)RI-40: It's here at last! The ultimate variable inductor. Isn't
>your tuner or amplifier project worth the very best? Made exclusively
>for Surplus Sales of Nebraska.
>
>.1-40 uH variable edge wound inductor. Taper wound lower end (higher Q)
>for better results beyond 20 MHz. Enough inductance for work below 160
>meters too. All rf surfaces are thick silver plated. Quad 10 amp
>contact sets on all rotating connections; coil to rotar; rotor to shaft
>armature; shaft armature to end
>plate contacts. There are no weak links with our mil-spec design.
>
>Perfect for 2-10 kw antenna tuners, tank network for amplifier or
>anywhere a larger, high Q, variable inductance is required. Be sure to
>use our Turns Counter (SHW)TCV.
>
>5" wide, 5-1/4" high, 12-1/2" end to end, maximum dimensions. 1/4"
>shaft. Optional end stop kit for motor drive schemes. Add $ for kit, pn
>(IRV)RI-40ESK.
>
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
Rich...
R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|