In a message dated 4/13/03 10:16:27 PM Eastern Daylight Time,
garyschafer@attbi.com writes:
>
> Hi Carlos,
>
> If you are getting your power from a 3 phase line, and you have 120
> volts then there should be only 208 volts across the two phases. I ran
> into that problem at a military installation I was at one time. There
> was no 240 volts to be had. Only 120 and 208 or 3 phase. The amp would
> not work well on the 208.
>
> 73
> Gary K4FMX
It depends on the configuration of the transformer feed the outlet, either
"Y" or "Delta". It is conceivable that a small transfomer could be obtained
to perform the conversion and thereby raised the voltage.
73 de
Dave, WT8R
|