That is right George. My 127v is 121/122. And the 220 is around 217.
73 Carlos PY4RO
----- Original Message -----
From: "George & Marijke Guerin" <gmguerin@voyager.net>
To: "Carlos Augusto S. Pereira" <carlos.augusto@superig.com.br>;
<Wt8r@aol.com>; <garyschafer@attbi.com>; <amps@contesting.com>
Sent: Monday, April 14, 2003 9:20 AM
Subject: Re: [Amps] Question about ampifiers
> Gentlemen:
>
> The Y connection is probably designed for 220 across two poles with a
single
> leg to ground of 127 VAC, similar to Curacao. It works fine on
amplifiers,
> and some of the locals and contesters use 10% step down transformers to
> power their 120 VAC transceivers, not having a 220 tap, to a supply
voltage
> of 110 - 115 VAC for better safety.
>
> 73 George K8GG
>
> ----- Original Message -----
> From: "Carlos Augusto S. Pereira" <carlos.augusto@superig.com.br>
> To: <Wt8r@aol.com>; <garyschafer@attbi.com>; <amps@contesting.com>
> Sent: Sunday, April 13, 2003 11:34 PM
> Subject: Re: [Amps] Question about ampifiers
>
>
> > Yes, Dave is right. The laundery machine is connected to a 220v outlet.
> The lower voltage measured is 217 and the highest is 222.
> >
> > 73 Carlos PY4RO
> > ----- Original Message -----
> > From: Wt8r@aol.com
> > To: garyschafer@attbi.com ; carlos.augusto@superig.com.br ;
> amps@contesting.com
> > Sent: Monday, April 14, 2003 12:28 AM
> > Subject: Re: [Amps] Question about ampifiers
> >
> >
> > In a message dated 4/13/03 10:16:27 PM Eastern Daylight Time,
> garyschafer@attbi.com writes:
> >
> >
> >
> > Hi Carlos,
> >
> > If you are getting your power from a 3 phase line, and you have 120
> > volts then there should be only 208 volts across the two phases. I
ran
> > into that problem at a military installation I was at one time.
There
> > was no 240 volts to be had. Only 120 and 208 or 3 phase. The amp
would
> > not work well on the 208.
> >
> > 73
> > Gary K4FMX
> >
> >
> >
> > It depends on the configuration of the transformer feed the outlet,
> either "Y" or "Delta". It is conceivable that a small transfomer could be
> obtained to perform the conversion and thereby raised the voltage.
> >
> > 73 de
> >
> > Dave, WT8R
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
> >
>
>
>
>
|