Amps
[Top] [All Lists]

Re: [Amps] Maximum RF output in practical application: 4-250A

To: "'Joe Isabella'" <n3ji@yahoo.com>, <amps@contesting.com>
Subject: Re: [Amps] Maximum RF output in practical application: 4-250A
From: "Joe Subich, W4TV" <w4tv@subich.com>
Date: Mon, 3 Jul 2006 15:28:44 -0400
List-post: <mailto:amps@contesting.com>
N3JI writes: 

> Necessary Bandwidth. For a given class of emission, the width of the 
> frequency band which is just sufficient to ensure the transmission of 
> information at the rate and with the ***quality required*** under 
> specified conditions. (Emphasis mine).

In Part 96.113 Broadcasting and Music are specifically prohibited. 
The only justification for medium fidelity of high fidelity audio 
is for "broadcast" purposes ... in fact, licensees in the medium 
and high fidelity services have "proof of performance" burdens that 
they must meet.   

Part 2 specifically assumes the quality necessary for the communications 
purpose covered by the rules, not some arbitrary standard of chosen at 
the discretion of one licensee.  If the "licensee's discretion" standard 
were adopted, national/international regulation as well as international 
standards would go out the window.  It is incredibly easy for one licensee 
to say "I need 1080 lines of video" another say "I only need 720" and a 
third to say "well I need 1500."  The same thing in the audio area. 

It is for that reason that the Commission (and ITU) have generally 
settled on 2.5 KHz for basic voice quality (two-way dispatch, "toll 
quality," public safety/service, etc. including amateur), 5 KHz for 
moderate fidelity service (including nighttime AM and international 
broadcast) and 15 KHz for high fidelity (FM broadcast) services.  For 
you to arbitrarily decide that you "need" 4 or 5 KHz quality is just 
as absurd as the lid who operates "all knobs to the right." 

73, 

   ... Joe, W4TV 
 


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>