Thanks to all those who responded with suggestions.
Photo Shop is probably the best answer, but since I have no artistic
ability at all, is not an option.
Two bottles of Tarn-x were purchased (expensive!) and that wasn't even
enough to "dip" my parts and cover them.
Tried the water/salt/aluminum foil suggestion and it did not work at
all. Not even a trace of cleaning action. Maybe it was because I ran out
of salt before I got to a saturated solution. Will try this again after
another trip to the grocery store.
The Tarn-x does clean the silver plated coil but it takes considerable
rubbing. No way I'm gonna sit here for hours and swab the insides of
that edge wound inductor! I dipped it and it is a bit cleaner than it
was but not "bright" by any means.
I'll amend this post if I make any additional progress.
73, Larry
Larry - W7IUV
DN07dg
http://w7iuv.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|