Amps
[Top] [All Lists]

Re: [Amps] SB-220 troubles

To: amps@contesting.com
Subject: Re: [Amps] SB-220 troubles
From: Scott McGrath <mcgrath@fas.harvard.edu>
Date: Fri, 13 Feb 2009 14:16:40 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
In my case aviation with the ATC suffix Heavy - In general aviation you 
screw up and we read about a SK who's other hobby was flying,   in 
commercial it leads on CNN.

The safety habits learned last a lifetime also the fact that screwups 
are inevitable the trick is that you need to make MORE than one to cause 
injury or death.   Saying one will never make a potentially fatal 
mistake is one giant step down the road to that mistake.

For my restoration work I have a air manifold I have three types of air 
available

1 - Air with oil mist for air tools
2 - Filtered Clean Dry air for painting and sandblasting
3 - Shop air

All air lines have different incompatible connectors so it is impossible 
to use the 'wrong' set of hoses or supply.  I never have to worry about 
my finishing hoses having oil in them and ruining a paint job and I 
never have to worry about using an air tool for an extended period and 
blowing it up due to lack of lubrication.

Heck I own a shopsmith 510 and that has just minimal guards and safety 
systems which I check regularly I like it as it has sufficient safety 
for a reasonable man but no excess guards which get in the way of 
getting the job done.

my 0.02

Scott N1JIN


Scott N1JIN



k7fm wrote:
> "Yes I am one of those safety first guys also a engineer by training and
> spent a lot of time in the aviation industry where there are no second
> chances to do it right "
>
> There is a big difference between operating a high voltage supply 
> without any covers on it and operating a supply with a cover and lots 
> of screws, especially when it has danger high voltage signs on it.
>
> Comparing it to the aviation industry, I regularly start the engine of 
> my friend's aircraft by propping it.  The prop does not have any 
> safety screen around it.  I could trip and cut my head off.  I could 
> sneeze at the wrong time and lose an arm.  I am much more concerned 
> about that than the possibility of removing a dozen screws while I am 
> sleeping and not grounding out the caps before working on the set.
>
> As to opening up the set during a 2 day contest and forgetting all 
> sense of self-protection, it is no more likely than going out to cut 
> wood with my chain saw after a drinking binge.
>
> When I was a kid, I used to ride around in a car without a child 
> restraint and without air bags.  I drank from garden hoses made with 
> lead, no doubt played with toys made with lead and dove from bridges.  
> I climbed towers that did not have protective devices and even ate 
> eggs and hamburger that were not cooked.
>
> The thing is, that a safe person will assume that the protective 
> devices have all failed - so take the proper precautions whether or 
> not the devices are installed or removed.
>
> I leave the protective devices in place, but I do not blame anyone for 
> removing them and I certainly do not want to lecture him that my ideas 
> on safety trump his.
>
> 73,  Colin  K7FM 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>