Hi Bill,
I work in the electric utility industry and the safety rules state that all
energized equipment shall be de-energized if at all possible prior to
working on it. I would never grab a hot conductor with my bare hands. Now I
realize that this is not the case but removing a hot conductor from a power
supply just because you want to and without any personal safety concerns is
in my opinion a real gamble. When working on high voltage I'm never in such
a hurry that I cant wait for the bleeder resistors to do thier job and make
the B+ connection after the supply discharges.
Jeff, KA0JW
----- Original Message -----
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
To: <amps@contesting.com>
Sent: Saturday, September 11, 2010 10:30 PM
Subject: Re: [Amps] Amps Digest, Vol 93, Issue 16
> ORIGINAL MESSAGE:
>
> On Sat, 11 Sep 2010 15:40:22 -1000, Ken Brown
> <ken.d.brown@hawaiiantel.net> wrote:
>
>>Trying to hot plug or hot unplug a high voltage wire is hazardous whether
>>it is shielded or not.
>
> REPLY:
>
> Not if the right connector is used.
>
> With an unshielded, deeply recessed female connector on the PS side
> and a flying lead hard wired into the amp side, you can hot-plug all
> you like with no danger.
>
> There must be a solid ground connection between the two chassis, but
> that is true for any connector configuration.
>
> Bill, W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|