The VNA does not measure the VSWR on the line. It measures VSWR at the
input to the VNA unless you do a cal at the load end of the line to remove it's
effect.
73, Roger
On 1/13/2015 8:47 AM, Paul Christensen wrote:
"I forgot to include that with just a 4 foot cable on the output of the tuner
between tuner and 75 ohm load the SWR was 1.8:1. With the 10 foot cable SWR
was 1.46:1.
With the 10 foot and 4 foot cable the SWR was 1.4:1"
In the above experiment, on what line section is the SWR being sampled to
yield these results? Before or after the tuner? Also, do all line sections
have a Zo = 50?
Paul, W9AC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|