Jim,
In forced reload you can only upload software. You can not do an Open
Remote or access the unit. This is normal and cannot be changed. Load the
bin file in Forced reload and then reboot in normal operation mode and you
can access the unit.
Doug Harman
KarlNet, Inc.
525 Metro Place North
Suite 100
Dublin, OH 43017
614 822-5275 x 123
614 822-0024 fax
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Jim
> Sent: Tuesday, August 20, 2002 11:05 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Forced reload problem
>
>
> I have an AP-1000 in forced reload mode and I can use the configurator to
> scan it. I then change the IP address and try to connect to the
> unit. I get
> a message back which says "Signature of remote bridge is not recognized.".
> Is there anyway to access the unit?
>
> Jim
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|