No.. you cannot do an Open Remote when you have the unit in Forced Reload.
You can only do Upload Software.
Doug Harman
KarlNet, Inc.
525 Metro Place North
Suite 100
Dublin, OH 43017
614 822-5275 x 123
614 822-0024 fax
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Dan Metcalf
> Sent: Tuesday, August 20, 2002 12:24 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] Forced reload problem
>
>
> Newer config.exe?
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Jim
> Sent: Tuesday, August 20, 2002 11:05 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Forced reload problem
>
> I have an AP-1000 in forced reload mode and I can use the configurator
> to
> scan it. I then change the IP address and try to connect to the unit. I
> get
> a message back which says "Signature of remote bridge is not
> recognized.".
> Is there anyway to access the unit?
>
> Jim
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
>
>
> ---
> [This E-mail scanned for viruses by Declude Virus]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|