Re: [Karlnet] Engeniustech Prisim 2 cards...doesn't seem to be working properly

["Caleb Carroll" <karlnet@pathcom.ca>]

Notice the "CE" certification at the end of the line?  This is a card made for 
use in Europe.  Are you somewhere in europe?  If so, you probably won't be able 
to legally use the FCC certified 200mW card.

*********** REPLY SEPARATOR  ***********

On 2003-May-07 at 10:43 AM Bob Hrbek wrote:

>I'm using one of these engeniustech cards in an AP-1000 w/ Karlnet
>ISP-Base
>4.31
>http://www.engeniustech.com/cs/file/2511/el2511cdplusext2spec.pdf
>
>The specs say it can operate at 200mw or 100mW.   Does it run at 200mW by
>default?  By watching signal levels it seems like it is only operating at
>100mW.
>
>Anybody else using them and seeing the signal levels relavant to 200mW
>radios?
>
>-bob
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet