Look again at the PDF:
RF Output Power 23dBm(200mW)--FCC
20dBm(100mW)--CE
----- Original Message -----
From: "Caleb Carroll" <karlnet@pathcom.ca>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Wednesday, May 07, 2003 1:54 PM
Subject: Re: [Karlnet] Engeniustech Prisim 2 cards...doesn't seem to be
working properly
> Notice the "CE" certification at the end of the line? This is a card made
for use in Europe. Are you somewhere in europe? If so, you probably won't
be able to legally use the FCC certified 200mW card.
>
> *********** REPLY SEPARATOR ***********
>
> On 2003-May-07 at 10:43 AM Bob Hrbek wrote:
>
> >I'm using one of these engeniustech cards in an AP-1000 w/ Karlnet
> >ISP-Base
> >4.31
> >http://www.engeniustech.com/cs/file/2511/el2511cdplusext2spec.pdf
> >
> >The specs say it can operate at 200mw or 100mW. Does it run at 200mW by
> >default? By watching signal levels it seems like it is only operating at
> >100mW.
> >
> >Anybody else using them and seeing the signal levels relavant to 200mW
> >radios?
> >
> >-bob
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|