It's a shame that with 4 interfaces on the KN-200 that you can't define L2
bridge groups - For example, define Interfaces 1 & 2 as "Group 1" and
Interfaces 3 & 4 as "Group 2" so that you can then route between Group 1 &
Group 2.
*********** REPLY SEPARATOR ***********
On 2004-04-26 at 10:34 PM Paul Horak wrote:
>Anybody know if you can bridge and route on the same
>radio (KN200 in this rather bizarre case :-))? If so,
>please can you share the config? Turning on routing
>seems to automatically deny bridging of IP traffic.
>
>Cheers,
>
>Paul
>
>
>
>
>
>__________________________________
>Do you Yahoo!?
>Win a $20,000 Career Makeover at Yahoo! HotJobs
>http://hotjobs.sweepstakes.yahoo.com/careermakeover
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|