My York air-source heatpump causes minor video interference to the bedroom TV
set that is hooked-up to an outdoor Yagi but not to the family room TV that is
hooked up to a satellite receiver.
73,
Julio VE3FH
>
> From: "Olinger, Steven L" <steven.olinger@mnsu.edu>
> Date: 2006/01/19 Thu AM 11:10:53 EST
> To: <rfi@contesting.com>
> Subject: [RFI] Tv interference
>
> I recently had a new Trane high efficiency furnace installed in my home.
> When the burner comes on, channels 2-6 have interference on the screen.
> I use an antenna for reception, not cable or satellite. Trane has been
> contacted, but are not sure what the problem is. I have replaced and
> rerouted all the coaxial cable from the antenna to the television sets.
> The fan runs all the time at different speeds, but when the furnace
> calls for heat the interference starts. All TV sets in the house
> receive the same interference. Has anyone dealt with this problem or
> know of a solution?
>
>
>
> Steve Olinger
>
> Electrician Supervisor
>
> Minnesota State University Mankato
>
> Phone 507-389-5170 Fax 507-389-6664
>
> E-mail steven.olinger@mnsu.edu
>
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|