I'm not sure what to call it, but the "background" noise sounded different
on each. Any reason for that?
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Barry N1EU
Sent: Saturday, February 07, 2004 11:00 PM
To: tentec@contesting.com
Subject: Re: More Re: [TenTec] Orion redefines the meaning of ... AGC
OFF
--- K3BU@aol.com wrote:
> K6SE tests are not urban legend. He is one of the
> top and accomplished hams,
> he knows the stuff and if you knew more about it,
> you might be more inclined
> to have closer look at the problem rather than
> ridiculing and singing praises
> and hallelujahs about crap. I will repeat his test
> under perhaps more
> controlled situation, but so far what I have seen, I
> agree with Earl's conclusions.
>
I searched for a weak signal on a relatively quiet
band to conduct an experiment comparing the Orion with
a FT-1000D. The Orion actually did sound a little
noisier than I thought it would although I think the
s/n ratio winner was a toss up, but you be the judge:
http://n1eu.tripod.com/orion/1000D_compar.mp3
It's a 2-1/2 minute clip of a slow weak cw signal
starting with the Orion and switching back and forth
with audible switch pops. A couple of times you can
hear me adjust the Orion AGC. 250hz bandwith was used
on both receivers (1Khz roofing filter on the Orion,
preamp on).
73,
Barry N1EU
__________________________________
Do you Yahoo!?
Yahoo! Finance: Get your refund fast by filing online.
http://taxes.yahoo.com/filing.html
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|