TenTec
[Top] [All Lists]

Re: [TenTec] Orion Processing

To: tentec@contesting.com
Subject: Re: [TenTec] Orion Processing
From: Martin AA6E <msembx-aa6e@yahoo.com>
Reply-to: msembx-aa6e@yahoo.com,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 17 Mar 2005 17:24:39 -0800 (PST)
List-post: <mailto:tentec@contesting.com>
Design is a lot easier if you can guarantee the processor always has
scheduling headroom, enough RAM, etc.  Speed is no substitute for
correct logic, of course.

73, Martin AA6E


--- Steve Baron - KB3MM <SteveBaron@StarLinX.com> wrote:
> 
> ----- Original Message ----- 
> From: "Martin AA6E" <msembx-aa6e@yahoo.com>
> To: <tentec@contesting.com>
> Sent: Thursday, March 17, 2005 22:56
> Subject: Re: [TenTec] Orion Processing

> > 
> > On the other hand, a faster control processor might benefit
> everyone -
> > fewer hangups, etc.
> 
> I always view hangups as a possible design problem.
> 
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>