I have been running 8-38 amp hour Powersafe (Hawker) gas absorption mat
connected in parallel that also have each battery's B+ outlet fused, going
to a MFJ power block for distribution to two vhf/uhf rigs and two hf
rigs...a TT Paragon II and Omni VI.
For some reason the hf rigs do not like this particular power setup and will
tend to draw too much collector current going into a flat antenna load even
when the rf power output is set at minimum....if I run the hf rigs on
individual TT 961 power supplies, the condition does not exist. the Paragon
is more stable running off of my battery setup than the Omni.
I am now wondering if I would be better off using the existing batteries to
feed a ups, such as an APC 2200, and hooking up the individual power
supplies to the ups.
The batteries voltage range is from 13.02 to 14.16 vdc, with optimum voltage
of 2.27 vdc per cell, or 13.62 vdc per battery.
----- Original Message -----
From: "Eric F. Richards" <efricha@dim.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 05, 2007 1:44 AM
Subject: Re: [TenTec] emergency back up power
> At 12:20 AM 3/5/2007 -0500, Gary Hoffman wrote:
>>Paul,
>>
>>My array of batteries can provide about 1500 amp hours, provided that the
>>discharge rate is kept reasonable.
>>
>>No discount sources that I know of. That's because most batteries that
>>have
>>seen use have been handled so poorly that they have been significantly
>>impaired.
>
> May I throw in a contrary opinion?
>
> I'm running on 800 AH (24 VDC) of hospital pulls. They saw one year of
> service and were yanked. 80 AH gel-cells.
>
> The inverter is an Exeltech XP-1100 (1.1 kVA) -- too small for a
> legal-limit amp, but a fine sine wave inverter with less than 2% THD. A
> battery balancer lets me pull 12 volts directly for the various radios
> that
> use it. A West Mountain Radio RigRunner distributes the 12 V through
> Anderson PowerPoles.
>
> It goes without saying that I fuse the crap out of everything. The
> inverter has a separate 200 A Class-T fuse.
>
> The XP series from Exeltech is their "low cost" inverter line, and the
> 1100
> is as big as that series gets. If you want more power, you need a rack
> mount module with 1 kVA modules stacked with controllers, with the option
> of redundant power, etc.... and the cost goes sky high.
>
> ...oh, those batteries? Well, they're getting old. I've gotten almost 10
> years out of them, and need to replace them. But then, they only have
> done two deep/complete discharge cycles. I'll have no problem with using
> hospital pulls or NOS again.
>
> For those still reading, the charging system is 400 W of solar panels
> through a PWM charger with sense lines and temperature compensation.
> About
> $100 back in the day, and there are much better ones out there today.
>
>
>>Special electronics are not especially hard to work up yourself. You must
>>avoid over or undercharge, which is pretty much a matter of voltage
>>regulation. And every so often you must apply an equalizing charge to
>>make
>>sure that all batteries are properly topped up. You can Google that
>>phrase
>>and come up with lots of stuff. Or look at Home Power Magazine.
>
> That's fine for wet-cells, but I prefer the safety of gel cells at the
> cost
> of energy density and $$$. I'd go with a commercial circuit if you
> haven't
> done a charge circuit before. (You only equalize a gel-cell once, and
> then
> you throw it away. :-))
>
>
>
>>Overspend on the batteries and make savings elsewhere if you can.
>
> Again, I think you can get away with certain things with the
> batteries. New-old stock is fine, as long as they aren't more than 18
> months old, as are hospital pulls. Wet cell types that have never seen
> electrolyte should be fine as long as they weren't physically damaged
> (dropped, etc.). However, UPS pulls from non-life-critical systems aren't
> worth it. Pulls from repeater sites are a no-no.
>
> It helps if you know people who've been through this before in your local
> area. At local hamfests here in Colorado, there are dealers who work in
> good faith and there are the rest. Find out from someone who's been
> through it all before.
>
> Regards,
>
> Eric F. Richards, KB0YDN
>
> --
> Eric F. Richards
> efricha@dim.com
> "The weird part is that I can feel productive even when I'm doomed."
> - Dilbert
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|