Hi Bob,
I am no expert, however I would suspect the optical encoder on the main tuning
dial, or else perhaps one of the interconnecting cables for it has worked loose.
73,
Ken W7TS
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Bob Towers
Sent: Monday, July 30, 2007 09:30
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Frozen display on Omni V.9
I have noticed in the last month or so that the display on my Omni V.9
freezes up after about 20 minutes operation. Recently it has got worse
and the display is frozen when I switch on the rig. Rotation of the
tuning control does nothing except change the last digit on the display
by ± 1 (=100Hz). All other controls work correctly.
I am able to tune the rig using CAT control, by the way. Disconnection
of the CAT serial link makes no difference.
Any help on this would be much appreciated.
73 and thanks in advance
Bob Towers
MM0RKT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|