Hi,
I have also just acquired an Omni VI Opt3 and I also had a great deal of
problem with getting the radio to talk to a PC.
After making two cables that would not work, I had a look inside the radio.
What I found was that the way the internal wiring was a cross over cable was
required as mine was connected up rx to rx and tx to tx.
I could not be bothered to alter the cable so I reversed plug 72 connected
to the max232 ic on the logic board and it all worked.
The radio code is set in option three I think and default is 04.
By the way has your radio got a heterodyne on the PBT that you can hear on
CW with narrow filters?
regards
Tim
gm4lmh
----- Original Message -----
From: "DW Holtman" <tubestuff@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, January 16, 2009 10:56 PM
Subject: [TenTec] Ham Radio Deluxe
> Hello,
>
> I recently aquired a Omni VI Plus and I wanted to know if anyone uses Ham
> Radio Deluxe with it. I cannot get it to communicate with my computer. I
> first tried using a DB-25 (Radio) to a DB 9 through a Belkin serial to USB
> adapter, no luck. Next I wired a DB-25 to DB-25 thinking this set up did
> not
> like the Balkin. Still no luck. I told HRD that I have a IC-735 as per the
> manual.
>
> Any ideas? Thank you in advance.
>
> Best,
> DW Holtman
> WB7SSN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|