| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] RF Ground |
| From: | Jim WA9YSD <wa9ysd@yahoo.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 5 Apr 2009 16:34:12 -0700 (PDT) |
| List-post: | <mailto:tentec@contesting.com> |
If you were checking grounds in a newly developed project with new houses, what would you use to check the grounding to each house? The fire hydrant. You would run heavy 00 welding cable from the hydrant to each house and measure the resistance. Out in the country you would use your well casing as your reference and measure resistance to various points. RF as far as I am concerned is less than 1 OHM. Electrical standards is 25 ohms or so. Every thing radiates so you have to take other measures. Keep The Faith, Jim K9TF/WA9YSD |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni VI / +, Wayne Whitman |
|---|---|
| Next by Date: | Re: [TenTec] V. 2.041XL Summary, Comments and updated Wishlist, Jim M. |
| Previous by Thread: | Re: [TenTec] RF Ground, Jim WA9YSD |
| Next by Thread: | Re: [TenTec] RF Ground, Bob McGraw - K4TAX |
| Indexes: | [Date] [Thread] [Top] [All Lists] |