Re: [TenTec] Corsair frequency display issue

[Bwana Bob <wb2vuf@verizon.net>]

Gil:

Just to clarify, the caps and diodes to check are inside the shielded 
box that encloses the frequency counter board, not in the VFO.

                                        73,

                                        Bob WB2VUF

g p wrote:
> Somehow I misunderstood and thought the jumper was inside the radio by the PTO. 
> The VFO jumper in the back of the radio is there, I actually took it out and 
> dabbed it with deoxit beore I put it back in, cleaned all connectors inside the 
> rig, checked for loose components but the display still shows the MHZ 00. first 
> digits off on a couplle of bands, the KHZ .000 are accurate on all bands. Radio 
> is functional and as long as I know which band Im in Im ok with that. I will 
> gather more information for a while before I decide to go any further, I've 
> been recommended to check caps and diodes inside the enclosed VFO which I will 
> do later on sometime and will post the results.
>  
> Thanks all for the help, Gil
>
>       
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec