TenTec
[Top] [All Lists]

Re: [TenTec] help in soldering pl259 outside

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] help in soldering pl259 outside
From: "David W LeJeune, Sr" <lejeuned@centurytel.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 5 Apr 2010 17:15:29 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I've found that the butane irons sold by Radio Shack work very well in
soldering PL259's, and they are small and portable

Dave WN5V

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of David Goncalves
Sent: Monday, April 05, 2010 4:54 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] help in soldering pl259 outside

http://www.projectautox.com/large_soldering_irons.jpg

On Mon, Apr 5, 2010 at 5:52 PM, John Molenda <cdistflatfoot@gmail.com>wrote:

>  Well it's that time again that is Antenna time .  I was out side
yesterday
> in 60 degree temp and had a very diffucult time soldering on some
> connectors . Does anyone on the reflector have any tricks for soldering
> outside both my irons were not hot enough .  Does anyone make a special
> slodering tool for such a job ?  thanks John kb2huk
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>



-- 
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>