Yes, thank you Rod and all. I needed to be more specific in my terminology.
As Rod stated I am speaking of the DSP variable BW.
It was a good suggestion, and I will reload the software load and do the
necessary master reset and see if the situation is still there. Initially when
I downloaded the new release there were no error flags displayed but I will do
this again and assure there are no issues in that area.
I'll provide another update tomorrow.
Steve - W5JK
On Jun 17, 2010, at 8:36 PM, ROD wrote:
> they are talking the dsp bw not the trsnsmitt bw i set my dsp bw to 2800
> turn off and back on the dsp bw goes to 3000
> ----- Original Message -----
> From: "Troy W6HV" <w6hv@verizon.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Thursday, June 17, 2010 9:29 PM
> Subject: Re: [TenTec] bugs in Orion firmware 2.044A
>
>
>> Ditto with mine. Goes to what I had set previously.
>> Troy, W6HV
>>
>> --------------------------------------------------
>> From: "Phil Howlett" <w9xx@hoosierbroadband.com>
>> Sent: Thursday, June 17, 2010 5:25 PM
>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>> Subject: Re: [TenTec] bugs in Orion firmware 2.044A
>>
>>> Same here....No problem. Plays very well. Bad download?
>>> W9XX
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|