TenTec
[Top] [All Lists]

Re: [TenTec] PTO Rebuild or not?

To: tentec@contesting.com
Subject: Re: [TenTec] PTO Rebuild or not?
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Reply-to: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 30 Nov 2010 13:37:08 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Some PTOs need only fresh grease, the PTO in my Corsair II needed new 
metal parts, the races for the vernier were worn badly and it still 
would have slipped with only fresh sticky grease.

73, Jerry, K0CQ

On 11/30/2010 1:11 PM, Don Rasmussen wrote:
>>> I own an Omni D that works well and enjoy using, except the PTO is 
>>> beginning to drag.
>
> Sending to TenTec would be a terrible waste, unless you cannot deal with 
> teeny little tiny parts. Eyesight and coordination are necessary, brain power 
> is not. It is very easy to figure out with the TT instructions and very 
> satisfying when you have finished.
>
> In my opinion, the rebuild kits are generally not necessary nor is taking 
> apart the insides of the PTO. Just open the PTO enclosure, mask the PCB, 
> spray the front bearings and upper spring with WD40 to dissolve the grease. 
> Then use fingers to press in some new grease on those two areas and work the 
> mechanism a bit.
>
> Ultimately, if you need to take the thing down to little pieces, it is not at 
> all difficult but for example the bearings are the size of BB's, it's small 
> work.
>
> Great Winter project - easy and fun.
>
>
>
>
>
>
>
>    Have the kit to rebuild it, have never done a rebuild before, but
> am reasonably mechanically capable. TT tells me the price is $125 to rebuild
> it, and then of course the shipping will likely add at least another $50.
> They tell me alignment after rebuild is probably not necessary.
>
> So, appreciate advice about rebuilding/having TT rebuild it/ or avoiding the
> issue by just selling the rig,    Finally, assuming I rebuild, what is the
> best solvent to remove the old grease?  Is Varsol ok?
>
> 73, Curt KB5JO
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>