TenTec
[Top] [All Lists]

Re: [TenTec] OII V2.044A

To: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OII V2.044A
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 27 Feb 2011 01:39:15 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I often use a Timewave DSP 599zx on my receivers (I have two of those
units)  with good results.   First, I like the high-pass and low-pass 
frequency cut off filters, as they are fairly (not completely) effective 
at cutting high and low noise - i.e. that which is outside the main 
speech intelligibility frequency range.

Second, with varying success, I use the random noise filter coupled with 
the DSP-599zx  AGC feature turned on, or off, depending.... it can 
matter either way sometimes yes, sometimes no;   and it can help with 
noisy signals.   I especially like it with my older Kenwood R5000 
receiver.

I sometimes run the final audio through a stereo graphic equalizer, with 
the high and low frequency ranges cut as much as possible, and with some 
of the mid-range frequency bands set up a bit; and this combination can 
be an effective way of tailoring the audio to the speech frequency 
spectrum, while cutting out noise above and below that.

Unfortunately, these have their limitations and cannot, of course, make 
a purse out of a sow's ear,  for which I would have paid triple the cost 
of all my accessories !   Like... who wouldn't ?

MOST of the time... I do not need these accessories, but they have 
occasionally made the difference between making the contact or not. 
But, as in the case of microphone input accessories (equalizers, 
compressors, noise gates,  etc.)  a little can be good, too much can be 
bad, and judicious use thereof is always the order for the day.

Just MY take,  anyway...

PS  = I think making Jerry's filter sounds like a fun weekend DIY project
and will likely enlist my local Elmer/radio engineer genius to look over 
my shoulder as I proceed.   I am in the process of developing a 
switch-box - patch breakout box to route all my audio to various 
external audio devices, including the computer, amplified studio 
speakers, the equalizer, DSP filters, and the like.    I may get 
ambitious enough to incorporate Dr J's audio filter right inside the 
box, and kick it in or out with a switch.   Nothing like being able to 
select various different tools from the tool box immediately while 
operating.

Happy Trails.
=======================  Richards / K8JHR  =========================

On 2/26/2011 8:55 PM, Dr. Gerald N. Johnson wrote:

> I have also used a Timewave DSP59+ but its not clean from HF hiss. The
> DSP in my FT-857D is pretty good about filtering high frequency hiss.
>
=================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>