Well... Ten Tec does offer a 30 day return policy. If you are not
happy, send it back.
Sure... it could be a QC issue at the factory. Or maybe a decision
to pass as "up to spec" items that are in a certain range of
performance.
To do a more thorough check, I bet the price would have to be
increased. Mil spec stuff costs at least 10 times more than other
gear, in part because of that. $3K is a lot of money to most hams,
but in the world of commercial and military gear, it's chump change.
73 de Ray
K2ULR
On Apr 1, 2011, at 8:02 PM, Mike Bryce wrote:
I'll keep this short as two thumb typing is hard to do.
I understand the electronic aspect of it as well as the tolerance
and logarithm of real power in the real world.
Please, please, please understand I KNOW that no one on the other
end will know the difference.
But, I paid almost $3000 for a radio that displays on the front
panel 100 watts output when the real power into a dummy load @13.9
volts @ the radio power connection I have 76 watts on 20 meters out
of the box brand spanking new.
This is NOT a 'simple adjustment-- no one will notice' problem.
No one, not me, not you, should pay three grand and then need to
crack the case open to adjust anything.
This is not a 'no one can tell the difference problem,' this is a
quality control problem.
If the display on my brand new $3k Omni 7 says 100 watts, then by
god the power output should be "close."
85 watts is fine, but the display should reflect the rf output of
85 watts (not lab gear, I know)
With sore thumbs,
Mike
Sent from my iPhone
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|