TenTec
[Top] [All Lists]

Re: [TenTec] SLIGHTLY OT

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] SLIGHTLY OT
From: Steve Hunt <steve@karinya.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 08 Apr 2011 20:35:34 +0100
List-post: <mailto:tentec@contesting.com>

On 08/04/2011 19:29, Dr. Gerald N. Johnson wrote:
A quarter wave center fed wire has low radiation resistance and is very
capacitive. Bad phase angle.

Correct - an EZNEC model of his antenna puts the feedpoint impedance at around 11-j930 Ohms

You run that through a 600 ohm line about a
quarter wave long, converts low R to high R and C to L.

No, that's wrong. A quarter wavelength of 600 Ohm line transforms 11-j930 to 4.5+j386.
His 110ft of open wire will transform 11-j930 to around 7+j290

So your balun
sees high impedance that may be causing core saturation (for sure in a
voltage balun) and you see high Z at the tuner.

A true 1:1 Guanella balun will not saturate because of a High Z differential load. The core flux is driven by *Common-Mode* current, not by differential-mode voltage.

Perhaps surprisingly the 10ft of LMR600 then has a major effect - transforming 7+j290 to 206+j1573

If you look at the L-network needed to match that impedance to 50 Ohms it requires much more inductance than the 238B is capable of. I wonder if your tuner is at max L as well as being at max C?

73,
Steve G3TXQ

<Prev in Thread] Current Thread [Next in Thread>