Re: [TenTec] Pegasus Control, new PC, port problems

[Carl Moreschi <n4py2@earthlink.net>]

The N4PY program sets the baud rate itself, so that is not an issue.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/19/2011 3:15 AM, Richards wrote:
> Hi Art -- I would check the baud rate.  Should be specified
> in the user manual.
>
> I do not have a Pegasus, but that often resolves issue I see
> with my Omni VII,  RX-230D, and TS-590s --  all of which seem to
> have similar issues when I do a re-build, and the baud rate is
> often the sticking point.  No guarantees, but I would check that
> out as you suggest.
>
> In any case, if that is not the issue, then you have eliminated
> that as the problem.
>
> ------------------
> Happy Trails.
> =======================  Richards / K8JHR  =========================
>
> On 6/19/2011 00:57, Art Trampler wrote:
>
> > However, I haven’t been able to get the Pegasus recognized.
> > Is there a particular Baud I should select?
> >
> > ______________________________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec