Hey... I had one of those once ... during my SWL days.
I thought it might improve my long (i.e., random) wire receiver antenna,
but I could never see any improvement no matter how I set it.
OK, so if that is a simplified version, I would take it Zero (0) on the
inductor scale means zero (0) inductance. Although it could be maximum
inductance if it was installed the other way around.
Comparing the schematic for each, it would appear the low side of the
inductor faces the radio input, and the high side faces the output - but
that does not indicate, for sure, which way the inductor is physically
oriented in the cabinet, and vis-a-vis the front dial.
Or does it?
And the MFJ 16010 description makes it sound like the whole circuit gets
reversed - which would reverse the direction of the inductor relative to
the current flow - rather than just alter the location of the fixed
capacitors relative to the same circuit/inductor direction.
On point, but I am still corn-fused.
Someone on the list talked me into getting an L/C meter but I have yet
to learn how to use it ! So much to learn, so little time.
---------------------- K8JHR ----------------------
On 7/28/2013 5:15 PM, Al Gulseth wrote:
(Hope I'm understanding your question right, HI!!)
There is a "budget priced" lower power "clone" (to use the term very loosely!)
of the 238 that might help you understand the concept of how the L network
functions. It is made by another manufacturer located a little ways southwest
of Sevierville in another "S" town: AKA the MFJ 16010T. Here's the manual:
http://www.mfjenterprises.com/pdffiles/MFJ-16010.pdf
The "executive summary" is that an L network is used to transform some low Z
to some higher Z, or vice-versa if the network is reversed. To quote from the
16010 manual:
"The connectors are labeled properly to match a transmitter to a higher
impedance. This is the normal connection.
To match impedances that are lower than your transmitter impedance (such as a
mobile whip), simply interchange the normal transmitter and antenna
connections to the MFJ-16010."
Simply put, when the cap is on the output side the transformation is L>H Z,
and when the cap is on the input it's H>L Z. The 238 series accomplish this
via the BYPASS switch, while the MFJ uses the less expensive and low-tech
method of reversing the connections to the unit.
The direction of current flow is immaterial in this case. And yes, determining
the actual zero inductance setting position would probably be beneficial in
using the unit....
73, Al
On Sun July 28 2013 2:45:22 pm Richards wrote:
Well, this is where I get corn-fused.
The user manual states it is a REVERSIBLE L-NETWORK, whereby the fixed
capacitors are either placed at the front of the circuit or at the end
of the circuit using the BYPASS switch. I presume the current always
flows in the same direction through the circuit, including the inductor.
(Heck, I am still learning to read schematic diagrams.)
From some of the previous comments, it sounds as if there is some
uncertainly as to the ZERO (0) inductor setting means the most or the
least inductance.
Is this not revealed in the schematic? Or do we have to open the lid
and look to determine the matter? And, would it not be the same from
unit to unit? Some comments seem to suggest the Zero (0) setting could
be different on some units.
Sorry if I missed a point along the way. It is still a mystery to me.
------------------- K8JHR -----------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|