| To: | Don Rasmussen <wb8yqj@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] OMNI 6+ Alignment question |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 29 Jul 2013 09:50:55 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Don, agree with what Bob said - you need to first perform an accurate BFO oscillator alignment and then check the frequency of WWV. 73, Barry N1EU On Mon, Jul 29, 2013 at 2:57 AM, Don Rasmussen <wb8yqj@yahoo.com> wrote: > My frequency display is now reading 60hz high for a WWV zerobeat on USB > and LSB. > > Can anyone suggest if this would be the TCXO going out of tolerance or > possibly there is a trimmer? > > de wb8yqj/6 > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] TT 238C will not tune, Rick - DJ0IP / NJ0IP |
|---|---|
| Next by Date: | Re: [TenTec] OT: Openwire/Window Line and Bad Wx, Scott Harwood |
| Previous by Thread: | Re: [TenTec] OMNI 6+ Alignment question, Robert Mcgraw |
| Next by Thread: | Re: [TenTec] OMNI 6+ Alignment question, Dennis R Baumgarte |
| Indexes: | [Date] [Thread] [Top] [All Lists] |