TenTec
[Top] [All Lists]

Re: [TenTec] 318 and qsk-5

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 318 and qsk-5
From: denton sprague <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 7 Dec 2013 18:13:49 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I used to have a Hallicrafters SX101A reciever and a HT32B transmitter with one 
of those Johnson TR switches….qsk ssb anyone??
On Dec 7, 2013, at 2:07 PM, "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> wrote:

> The reason that the amp had no T/R relay is, there were no transceivers back
> then.
> We had separate receivers and transceivers.
> Antenna switching was always done external to the transmitter.
> Transmitters had no T/R relay.
> The transmitter was simply connected to the input of the amp.
> 
> Many people used an external T/R relay to switch the antenna between the
> transmitter and the receiver.
> If you used an amp, you just used the same switching circuit but connected
> it to the amp's RF out.
> 
> Even cooler was the "Johnson Viking TR Switch."
> This was an external device with two vacuum tubes that automatically
> switched the antenna between the RX or TX (instantly) whenever it was
> activated.
> 
> I guess we can say the Ameritron QSK-5 is the descendant of the old Johnson
> Viking TR Switch.
> 
> 73
> Rick, DJ0IP
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>