My dream was to build an amp with 4x 1625's in push-pull parallel.
At the end of the day, I built the amp with 3x 811a instead - straight out
of the Handbook.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Bob McGraw
- K4TAX
Sent: Tuesday, December 10, 2013 2:18 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 318 and qsk-5
Nothing like class AB1 or AB2 push pull audio from a pair of 6V6GT's.
73
Bob, K4TAX
----- Original Message -----
From: "denton sprague" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, December 09, 2013 6:18 PM
Subject: Re: [TenTec] 318 and qsk-5
we had a cat that loved the top of that receiver on a cold winters day..but
she kept getting her claws hung up on the top covers vent holes.
Called her our "excess filament heat absorption unit".
I really miss that old SX101A..the audio was georgous..but it sure did like
to drift.
On Dec 8, 2013, at 10:44 PM, Richards <jrichards@k8jhr.com> wrote:
> ..., they weight in at some 135 lbs. ...
>
> ...and one won't need to worry about the desk
>> moving around when sending aggressive CW.
>
> _______________________________________________
>
>
> I would hope not! :-0
>
>
> I hope you can afford the electric bill... that
> is quite some heater! ;-)
>
>
> --------------------- K8JHR -------------------
>
>
>
> /
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|