The ground from the mike connector is a stranded wire about 1.5" in length
terminating to a ground lug that is bolted to the side of the chassis.
I carefully observed this as I had to replace my MULTI encoder. Thus it was
necessary to remove the front panel and the associated mounted mike
connector.
The digital and analog grounds are separate throughout the radio and are
connected at one point on the power distribution board at the rear.
73
Bob, K4TAX
----- Original Message -----
From: "Jim Brown" <k9yc@audiosystemsgroup.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, May 16, 2014 11:43 PM
Subject: Re: [TenTec] Eagle problem?
I stopped by the Ten Tec booth today, and looked at both an Eagle and an
Omni VII that were on display. I did not open them up, but it certainly
appeared that most of the connectors appear to be mounted to the circuit
board and in their enclosure such that the connector shells to not contact
the chassis.
I then had a brief conversation with John Henry, pointing to him what
looked very much like multiple Pin One Problems in these two radios, and
that they were a likely cause of the RFI complaints currently being
discussed on this reflector. He seemed to be paying attention. Because he
was quite busy in the booth, I purposely kept our discussion brief.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|