TenTec
[Top] [All Lists]

Re: [TenTec] I surrender

To: k8mp@aol.com
Subject: Re: [TenTec] I surrender
From: Carl Moreschi <n4py3@earthlink.net>
Reply-to: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 04 Mar 2018 06:54:14 -0500
List-post: <mailto:tentec@contesting.com>
I don't think the Omni VI implemented that command.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 3/4/2018 12:06 AM, k8mp@aol.com wrote:
They're talkin' Carl. The rig accepts the mode and QRG commands from the
PC but apparently it doesn't accept the command to xmit.


Sent from AOL Mobile Mail


-----Original Message-----
From: Carl Moreschi <n4py3@earthlink.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Sat, Mar 3, 2018 11:12 PM
Subject: Re: [TenTec] I surrender


There's 3 things that have to match.

Baud rate (probably 1200 but might not be )
CIV address (should be 04 )
Correct comport number.

If all those match it will work.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com <http://www.n4py.com>

On 3/3/2018 10:32 PM, Joe Papworth via TenTec wrote:
 > Gents,
 >
 > <div>I threw in the towel on making WinLink and Winmor work with my
Omni VI Plus. I have WinLink working over our local Mesh network and I
was hoping get it working on HF but no dice.
 >
 > Thank you Carl, Rod, Greg, and others who weighed in.
 >
 > Joe, K8MP
 >
 > Sent from AOL Mobile Mail</div>
 > _______________________________________________
 > TenTec mailing list
 > TenTec@contesting.com <mailto:TenTec@contesting.com>
 > http://lists.contesting.com/mailman/listinfo/tentec
 >
_______________________________________________
TenTec mailing list
TenTec@contesting.com <mailto:TenTec@contesting.com>
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>