I tried those also Carl. I tried all four combos, both on, both off, and each
one on by itself.
ARGGGGG!
<div>Joe, K8MP
Sent from AOL Mobile Mail
-----Original Message-----
From: Carl Moreschi <n4py3@earthlink.net>
To: k8mp <k8mp@aol.com>
Cc: tentec <tentec@contesting.com>
Sent: Sun, Mar 4, 2018 09:52 AM
Subject: Re: [TenTec] I surrender
They are probably keying with RTS or DTR and not using an Icom command.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
<a href="http://www.n4py.com"; target="_blank">www.n4py.com</a>
On 3/4/2018 8:12 AM, <a href="mailto:k8mp@aol.com";>k8mp@aol.com</a> wrote:
> Hmmm...
> I run MMTTY and FLFigi on that same PC over the same connection and they
> key the Omni VI Plus fine.
>
> Those work but WinLink/Winmor does not, so it's gotta be something in
> the program or a setting in it.
>
> Later, Joe, K8MP
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Carl Moreschi <<a
> href="mailto:n4py3@earthlink.net";>n4py3@earthlink.net</a>>
> To: k8mp <<a href="mailto:k8mp@aol.com";>k8mp@aol.com</a>>
> Cc: tentec <<a href="mailto:tentec@contesting.com";>tentec@contesting.com</a>>
> Sent: Sun, Mar 4, 2018 06:54 AM
> Subject: Re: [TenTec] I surrender
>
>
> I don't think the Omni VI implemented that command.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> <a href="http://www.n4py.com"; target="_blank">www.n4py.com</a> <<a
> href="http://www.n4py.com"; target="_blank">http://www.n4py.com</a>>
>
> On 3/4/2018 12:06 AM, <a href="mailto:k8mp@aol.com";>k8mp@aol.com</a> <<a
> href="mailto:k8mp@aol.com?";>mailto:k8mp@aol.com</a>> wrote:
> > They're talkin' Carl. The rig accepts the mode and QRG commands from the
> > PC but apparently it doesn't accept the command to xmit.
> >
> >
> > Sent from AOL Mobile Mail
> >
> >
> > -----Original Message-----
> > From: Carl Moreschi <<a
> href="mailto:n4py3@earthlink.net";>n4py3@earthlink.net</a> <<a
> href="mailto:n4py3@earthlink.net?";>mailto:n4py3@earthlink.net</a>>>
> > To: Discussion of Ten-Tec Equipment <<a
> href="mailto:tentec@contesting.com";>tentec@contesting.com</a>
> <<a href="mailto:tentec@contesting.com?";>mailto:tentec@contesting.com</a>>>
> > Sent: Sat, Mar 3, 2018 11:12 PM
> > Subject: Re: [TenTec] I surrender
> >
> >
> > There's 3 things that have to match.
> >
> > Baud rate (probably 1200 but might not be )
> > CIV address (should be 04 )
> > Correct comport number.
> >
> > If all those match it will work.
> >
> > Carl Moreschi N4PY
> > 58 Hogwood Rd
> > Louisburg, NC 27549
> > <a href="http://www.n4py.com"; target="_blank">www.n4py.com</a> <<a
> href="http://www.n4py.com"; target="_blank">http://www.n4py.com</a>> <<a
> href="http://www.n4py.com"; target="_blank">http://www.n4py.com</a>>
> >
> > On 3/3/2018 10:32 PM, Joe Papworth via TenTec wrote:
> > > Gents,
> > >
> > > <div>I threw in the towel on making WinLink and Winmor work with my
> > Omni VI Plus. I have WinLink working over our local Mesh network and I
> > was hoping get it working on HF but no dice.
> > >
> > > Thank you Carl, Rod, Greg, and others who weighed in.
> > >
> > > Joe, K8MP
> > >
> > > Sent from AOL Mobile Mail</div>
> > > _______________________________________________
> > > TenTec mailing list
> > > <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a> <<a
> href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a>>
> <<a href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a> <<a
> href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a>?>>
> > > <a href="http://lists.contesting.com/mailman/listinfo/tentec";
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> > >
> > _______________________________________________
> > TenTec mailing list
> > <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a> <<a
> href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a>>
> <<a href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a> <<a
> href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a>?>>
> > <a href="http://lists.contesting.com/mailman/listinfo/tentec";
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
</div>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|