Towertalk
[Top] [All Lists]

[TowerTalk] Rotator Problem - follow up

To: <towertalk@contesting.com>
Subject: [TowerTalk] Rotator Problem - follow up
From: K7LXC@aol.com (K7LXC@aol.com)
Date: Mon, 3 Dec 2001 10:54:47 EST
In a message dated 12/3/01 5:23:44 AM Pacific Standard Time, T93m writes:

> could you tell do I need to wrap the connector first with tape then with 
> coax seal and why.

    If you put CoaxSeal directly on the connector - you'll never be able to 
get it off. It'll make a mess of the connector and it'll be relatively 
useless if you try to use it again. It's basically a one-time use. 

    If you put a layer or two of tape over the joint first and then the 
CoaxSeal, then you can peel it all off in the future and the connector will 
look brand new. 

    Commercial vapor wrap (i.e. db Products, Antenna Specialists, Andrew, 
etc.) does not adhere permanently to the connector - it'll peel off - but 
since most hams use CoaxSeal, you have to be more careful with it. 

    Be sure to put more tape over the vapor wrap and what you get is a 
bombproof joint. 

Cheers,
Steve    K7LXC
Tower Tech 

List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>