On Mon, Dec 03, 2001 at 08:23:44AM -0500, T93m@aol.com wrote:
>
> In a message dated 12/2/01 2:21:10 PM Eastern Standard Time, K7LXC@aol.com
> writes:
>
> << 1. Apply two wraps of premium electrical tape (Scotch 33+ or 88).
> 2. Apply a layer of vapor-wrap material. Vapor-wrap is simply a butyl
> rubber
> material that comes in rolls or sheets and does an excellent job of
> isolating
> the joint from the elements. (Okay - you can use CoaxSeal for this. DO NOT
> put CoaxSeal directly on connectors!) >>
>
> Hello Steve, could you tell do I need to wrap the connector first with tape
> then with coax seal and why.
Try removing the CoaxSeal after it has been on the connector and
exposed to the elements for a few years and you will understand.
Bob, N7XY
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|