Hi Garry!
Check out:
http://www.k3lr.com
Under "Station Engineering"
Click on How to install a PL259 connector
It gives you a different method that I have found to work very well.
73!
Tim K3LR
Garry wrote:
> This may have been discussed previously and if so I apologize for
> waisting space. I recently purchased a bag of 10 PL-259's from BuxComm.
> These are silver/teflon with a gold center pin. I have been out of ham
> radio for the last 16 years and haven't soldered any connectors since
> before 1990. I used to cut the outer jacket to the proper length, tin
> the braid then solder the braid through the 4 holes on the side then
> solder the center conductor. Back then, most PL259's were made in the
> USA and the area where the holes are was reduced in diameter so that the
> braid made good mechanical contact and would solder well if good quality
> cable was used.
>
> With these newer connectors, I find the diameter of the connector is not
> reduced in the area where the holes are so there is a gap between the
> inside of the connector and the braid of tinned coax. You can't fold the
> braid back over the outer insulation and get it that far in the
> connector as the fit is too tight. I have seen examples where some are
> soldering the braid to the outside of the PL259 but I like doing it
> from the inside as I used to do years ago.
>
> Does anyone know of a way to work with these newer PL259's? I wonder if
> all PL259's are made this way now?
>
> 73,
> Garry - WR4R
>
> _______________________________________________
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|