Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower Installation

To: TOWERTALK@contesting.com
Subject: Re: [TowerTalk] Tower Installation
From: Cqtestk4xs@aol.com
Date: Fri, 10 Aug 2007 11:54:30 EDT
List-post: <mailto:towertalk@contesting.com>
 
In a message dated 8/10/2007 3:41:27 P.M. Greenwich Standard Time,  
rtnmi@sbcglobal.net writes:

Also any  recommendations for guy wire or rope to be used would be  helpful.


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
Do NOT use rope.  If you don't have access to EHS cable at least use  
aircraft cable...3900 lb.
 
With the tower at that height, if it not next to the house, simply put a  
pulley on top of the mast, and hoist it up from the ground up the side of the  
tower.  I have done this many times.  I don't suggest you do this  while on top 
or anyone else on top of the tower.  Once the antenna is  in place, tighten 
the guys, climb the tower and set the antenna on the  mast.
 
The antenna should be around 5-6 sq ft, well within the load limit of  Rohn 
25.
 
Good DX-ing.
 
Bill KH7XS/K4XS



************************************** Get a sneak peek of the all-new AOL at 
http://discover.aol.com/memed/aolcom30tour
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>