Quite a few messages back someone on this reflector had posted a photo
of a machined or welded adapter piece that could be used to couple a
1/2 inch Drill to the shaft of a hand Operated winch.
When using the adapter I am referring to, as I recall, the winch handle was
removed
This was *NOT* the scheme shown at these web sites below
http://www.wd0m.com/winchadapter.html
http://www.n6rk.com/drill_adapter_for_winch/drill_applied.jpg
Anyone have the photo in their archives ?
73, Dennis N6KI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
