Towertalk
[Top] [All Lists]

Re: [TowerTalk] Electric Drill to Winch Adapter Question

To: Dennis Vernacchia <n6ki73@gmail.com>
Subject: Re: [TowerTalk] Electric Drill to Winch Adapter Question
From: Joe - WDØM <joe@wd0m.com>
Reply-to: joe@wd0m.com
Date: Mon, 09 Mar 2009 09:10:36 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hi Dennis,

Just happen to have it - I'll send it to you by e-mail as an 
attachment.  This image was what got me started thinking about using a 
1/2 inch drill to raise/lower the tower.  I'll also post it on my web 
page....you can find it here:

http://www.wd0m.com/adapter.html

73,

-- 
Joe Hannigan - WDØM
Pagosa Springs, CO

http://www.WD0M.com
http://www.pagosarocks.com
http://www.quiltqueen.net


Dennis Vernacchia wrote:
> Quite a few messages back someone on this reflector had posted a photo
> of a machined or welded adapter piece that could be used to couple a
> 1/2 inch Drill to the shaft of a hand Operated winch.
>
> When using the adapter I am referring to, as I recall, the winch handle was
> removed
>
> This was *NOT* the scheme shown at these web sites below
>
> http://www.wd0m.com/winchadapter.html
>
> http://www.n6rk.com/drill_adapter_for_winch/drill_applied.jpg
>
>
>
> Anyone have the photo in their archives ?
>
> 73, Dennis N6KI
> ________________
>   

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>